Vacupor® NT is the standard design of our vacuum insulation panel. Through the use of different barrier foils, Vacupor® NT can be adapted individually to the requirements of different applications, regarding life span, robustness and cost.
Vacupor® NT is characterized by a very good surface quality, tight dimensional tolerances and high format flexibility. Various geometries (curved, round, triangular, cut-out etc.) are possible.

Vacupor NT cross sectionPlease notice:
Vacupor® NT is not approved by the German building and construction authorites for building applications. Vacupor® NT may just be applied in areas where a Vacuum Insulation Panel is treated as an unregulated construction product, if an admission on a single case exists or will be obtained.

The procured technical approval no. Z-23.11-1662 only applies to the products referred to therein. Only these products meet the increased requirements for fire protection that are required to obtain an authorization. This is achieved by a modified barrier film.

The thermal conductivity value just describes the value of the Vacuum Insulation Panel under the mentioned conditions, measured in the center of the panel.The measured value does explicitly not correspond with the rated value, determined by the DIBt and may not be used in Germany for the implementation of thermal calculations for buildings.

 

 

 

 

 

Downloads

Data sheet

Safety

Product- and handling instructions